Tips on Replacing Broken Garage Door Springs

When you are facing a problem of broken garage door springs which need to be repaired or replaced immediately. You can handle it on your own or call a professional such as, garage door repair companies in Tempe to deal with them. These springs are heavy and long components that are used to raise or lower the garage door smoothly. Garage door springs repair or replacement means that you have the right expertise to take care of them.  The following are the important steps which will help you to finish the job easily and safely.

The most important step which you must follow while doing DIY garage door spring repair is to make that you have trued off the power supply to the garage door so there is no chance to get an electrocuted shock. Don’t forget to disconnect the garage door opener power cord and disconnect it from the garage door as well. For the modern garage door versions, you just need to remove the fuse or turn off the circuit breaker to stop the power supply.

Look thoroughly at the broken garage door springs and at the new one to confirm that they are both similar. Make sure that new garage door springs have type and dimensions similar to the older one. When you are replacing the springs avoid grabbing them. It is also good to make sure that you avoid touching the winding cones on new garage door springs. Use a permanent marker or any other writing instrument to make the end of the shaft to maintain tension. It is important to maintain the alignment of the garage door when you have finished the repairing project.

In the next step, you will have to wind the good spring off and unfasten the bolts securing the torsion cones and brackets of spring as well, and then remove the bolts safely. Once you have finished the same procedure with the broken springs, it is time to replace it with the new one and re-install the hardware. After winding the new springs, you need to check the balance of the garage door to evaluate its alignment. You will have to apply lubrication techniques to reduce the friction in the operations of the garage door.

Once you have checked the garage door is properly aligned and balanced and all the parts are perfectly mounted, it is a time to reconnect the garage door opener. It is good not to omit any safety points, that is why, test the garage door by operating it manually a few times to confirm that it is functioning properly. Although, fixing a broken garage door springs is an easy task but you need to make sure that you are following all the safety measurements. If you are don’t confident about your abilities and don’t know how to handle it, stay away from it because it can be dangerous if don’t handle correctly. You may lose your hands, fingers, or even life. It is strongly recommended that hire professional garage door repair technician to deal with the broken garage door springs.